- Independent control of 8 induction coils with 3 kW
- CANopen field bus interface
- low power dissipation by operating point optimization
Kuhnke Power Heat Controller, inductive
The induction generator is a device of the power electronics for feeding up to 8 induction coils with a power of 3 kW.
The unit can be operated on a three-phase network with a voltage of 360 V to 440 V and a frequency of 50/60 Hz.
The line current is rectified and fed to the DC link, from which the induction coils are supplied individually. It is controlled via the fieldbus CANopen.
General Technical Specifications
|Power Heat Controller||8 channel induction generator|
|Output power||Continuous power on all zones 15 kW
(peak power about 5 min 21 kW)
|Type of load||Induction coil according to specification, performance about 3 kW|
|Operating voltage||3 x 400 V AC (± 10%) without N conductor 50/60 Hz|
|Coverage||Circuit breaker 32 A, 3-pole, tripping characteristic B|
|Grid types||TT respectively TN system|
|Mains frequency||50/60 Hz|
|Adjusting range||0% … 100%|
|Supply voltage||Elektronic 24 V DC /18 V - 32 V, current consumption about. 0.5 A|
|Cooling||Active via an axial fan|
|Control||Operating and monitoring via PLC programm|
|LED status indication||1 x LED yellow field bus, 3 x LED status|
|Field bus||CANopen, adress via code switch|
|Functions||Output level for each output, Max Load, error,
|Housing material||Stainless steel|
|Protection||IP20, unit for mounting in a closed, metal cabinet|
|Power dissipation||200 W maximum|
Further Products of the Kuhnke Industrial Heater Line
We reserve the rights of modification, omission, error. Illustrations similar.